CUDA 2840 FRONT LOAD INDUSTRIAL PARTS WASHER

Cabinet: 14 ga., Tank 12 ga., Lid: 14 ga., steel, finished with a powder coat paint finish for long life and easy cleaning. Turntable to be constructed of 7 ga. steel with sealed ball bearings. Pull out debris screen located below parts basket to prevent small parts from falling into the tank. Door will have a safety shut-off and door latch mechanism. All welded seams must meet ASME Standards. Machine will have accommodations to allow for the following options:

– Automatic Water Fill
– Filtration System
– 7 Day Heater Timer
– 7 Day Oil Skimmer Timer
– Detail Brush with Side Sink
– Power Brush
– Two Tier Turntable
– Small Parts Basket
– Containment Ring
– Parts Tree
– Oil Drain Container

Rotating turntable must be gear-motor and chain driven. Rotation of turntable will provide complete spray coverage of parts being washed. Twelve (12) spray nozzles will be located on the spray manifold providing overlapping coverage of parts being washed.

An oil skimmer will be provided that removes floating oils from the surface of the sump tank cleaning solu¬tion. The skimmer will be constructed with a fan cooled electric motor, stainless steel disk skimmer and dual stainless steel scraper blades.

Electrical control panel shall have a 12 hour heater timer, 60 minute wash timer, 30 minute skimmer timer, turntable on-off switch and low water shutdown indicator light. Machine will include a manual door latch. An adjustable thermostat will control water temperature. A safety control switch will not allow pump or heater to operate if water level drops below a prescribed set point.